Table of Contents
Advertisement
Meridian 3
72
MECHANICAL CHARACTERISTICS
Cosmetic -
Mechanical data files -
Location of Philips logo -
Gap between panel and front bezel
Location of Control icons -
Color for resin/paint -
Fire enclosure request-
Resins
RoHS required
WEEE required.
Resin type/selection refer to Project Book Section 7.2 Plastic material.
If paint is used
RoHS required
WEEE require
If new painting type need to implement, refer to UN-D 1235.
Plastic mold tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.
Plastics flammability
All Plastics to be Flame Retardant UL 94-HB or Better.
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
Philips ID
ProE files required
Per Philips make-up sheet
< 1.2 (Typ.) mm
Per Philips Graphic sheet
Per Philips make-up sheet
Shielding Cover should fulfill international standard
Advertisement
Table of Contents
