Pro-Form PFEL71032 User Manual page 7

5. Identify the Left Handlebar (9), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Leg with two M8 x 43mm Button Bolts (50)
and two M8 Nylon Locknuts (46). Make sure that the
Nylon Locknuts are seated in the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Attach the Right Handlebar (not shown) to the
other Handlebar Leg (not shown) in the same way.
6. Apply a generous amount of the included grease to the
Pivot Axle (108) and to the two M8.5 Small Washers
(53). Insert the Pivot Axle into the Upright (2) and center
it. Reapply grease to both ends of the Pivot Axle.
Identify the Left and Right Handlebars (9, 10), which
are marked with stickers. Slide a Handlebar Spacer
(25) onto the short tube on each Handlebar, and rotate
the Handlebar Spacers so the small arrows are pointing
toward the floor. Then, slide the Handlebars onto the
Pivot Axle (108). Make sure that the Handlebars are
on the correct sides.
Tighten an M8 x 25mm Patch Screw (22) with an M8.5
Small Washer (53) and a Wave Washer (119) into each
end of the Pivot Axle (108). Orient the two Handlebar
Caps (23) as shown, and press the small tabs on the
Handlebar Caps into the two Handlebar Spacers (25).
7. Apply a thin film of grease to the shaft of a Union Bolt
Set (27) and to the two Bushings (28) in the left
Handlebar Leg (79).
Attach the left Handlebar Leg (79) to the left Flex Bar
(14) with the Union Bolt Set (27).
See assembly step 5 above. Tighten the two M8 x
43mm Button Bolts (50) in the left Handlebar Leg (79).
Make sure that the M8 Nylon Locknuts (46) are
seated in the hexagonal holes.
Repeat this step to attach the right Handlebar Leg
(79) to the right Flex Bar (14).
5
9
50
79
6
9
Tube
22
119
23
25
Arrow
53
Grease
7
79
28
Grease
14
27
7
Tube
46
Hexagonal
Holes
10
22
53
119
Tube
25 Grease
108
Arrow
2
79
27
14
23