Resetting Parameter Settings - Ranger DST-2420 Installation And Operation Manual

RESETTING PARAMETER SETTINGS

1. Press and hold the R button
Start button
weight position indicators stop fl ashing.
2. The Screen should now display "CAL CAL".
-
3. Press , below
F
and then .
These buttons must be pressed in sequence otherwise
you will bypass the fi rst parameter setting.
4. The Screen should now display "dIS" on the Inner
and a 3 digit number on the Outer.
5. Verify that the "dIS' setting matches the values
shown on the Parameter Settings Sticker located on the
inside of the balancer.
+ -
6. Press the or button below
the values to match the values shown on the Parameter
Settings Sticker.
and the
at the same time until the
+
, then below
NOTE:
to modify
7. When checking/modifying the "dIS" setting is
complete, press Distance
move on to the next parameter setting.
Once you move on to the next parameter setting,
you must restart this procedure if you would like
to edit the dIS value again.
8. The Screen should now display "In." on the Inner and
a 3 digit number on the Outer.
9. Verify that the In.- setting matches the Parameter
Settings Sticker located on the inside of the balancer.
+ -
10. Press the or
the values to match the values shown on the Parameter
Settings Sticker.
11. When checking/modifying the dIS setting is complete,
+
press button below
parameter setting.
Once you move on to the next parameter setting,
you must restart this procedure if you would like
to edit the In.- value again.
12. The Screen should now display "SFA" on the Inner
and a 3 digit number on the Outer.
13. Verify that the SFA setting matches the Parameter
Settings Sticker located on the inside of the balancer.
20
+
button below
NOTE:
button below to modify
to move on to the next
NOTE:
to