Advertisement
Quick Links
Advertisement
Summary of Contents for Detecto MZ-4.433
- Page 1 MANUAL MINI TRANSMITTER MZ-4.433...
- Page 2 INHOUD 1. Preface ................3 2. Replacing battery ............4 2.1 Opening the case ............. 4 2.2 Replacing battery ............. 4 3. Encoding ................ 5 3.1 Learning a new code ..........5 4. Notes ................7 Detecto Command Systems B.V. Page 2 ...
- Page 3 MZ‐4.433 1: PREFACE The new mini transmitter MZ-4.433 replaces the outdated 1- to 4 channel version with hard plastic switches. The new MZ-4433 transmitter is only available in a four-button 433MHz FM version. The push buttons consist of a soft rubber front, which is a great improvement compared to the older version.
- Page 4 2.2: Replacing Battery The battery is a 3V Lithium battery type CR2032. Replace the battery with the same type. The old battery can simply extended from beneath the clip. Note the (+) faces upwards when inserting the new battery. Detecto Command Systems B.V. Page 4 ...
- Page 5 When the transmitter does not receives a valid code within 5 seconds, the transmitter leaves the 'learning mode' and the LED goes out. To prevent the transmitter learns a strange signal, the range is very limited. Both transmitters should therefore lie side by side. Detecto Command Systems B.V. Page 5 ...
- Page 6 MZ‐4.433 Each switch on the transmitter can be learned with a separate code, but only one unique code per switch. It is possible to learn the same code on all switches. Detecto Command Systems B.V. Page 6 ...
- Page 7 MZ‐4.433 4: NOTES Detecto Command Systems B.V. Page 7 ...