Cisco MDS 9500 series Configuration Manual page 6

Using the Switch Setup Utility
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
General Software Firmbase[r] SMM Kernel 1.1.1002 Aug
General Software, Inc.
Firmbase initialized.
00000589K Low Memory Passed
01042304K Ext Memory Passed
Wait.....
General Software Pentium III Embedded BIOS 2000 (tm) Revision 1.1.(0)
(C) 2002 General Software, Inc.ware, Inc.
Pentium III-1.1-6E69-AA6E
+------------------------------------------------------------------------------+
|
+---------------------------------------+--------------------------------------+
| System CPU
| Coprocessor
| Embedded BIOS Date
+---------------------------------------+--------------------------------------+
Loader Loading stage1.5.
Loader loading, please wait...
Auto booting bootflash:/m9500-sf1ek9-kickstart-mz.2.1.1a.bin bootflash:/m9500-s
f1ek9-mz.2.1.1a.bin...
Booting kickstart image:
bootflash:/m9500-sf1ek9-kickstart-mz.2.1.1a.bin...................Image verification OK
Starting kernel...
INIT: version 2.78 booting
Checking all filesystems..... done.
Loading system software
Uncompressing system image: bootflash:/m9500-sf1ek9-mz.2.1.1a.bin
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
INIT: Entering runlevel: 3
Step 4 Make sure you enter the password you wish to assign for the admin user name.
---- System Admin Account Setup ----
Enter the password for "admin":
Tip
Note
Note
Step 5 Enter yes to enter the setup mode.
This setup utility will guide you through the basic configuration of the system. Setup
configures only enough connectivity for management of the system.
Cisco MDS 9000 Family Quick Configuration Guide
2-6
System BIOS Configuration, (C) 2002 General Software, Inc.
: Pentium III
: Enabled
: 10/24/03
If a password is trivial (short, easy-to-decipher), your password configuration is rejected. Be
sure to configure a strong password. Passwords are case-sensitive. You must explicitly configure
a password that meets the requirements listed in the "Configuring User Accounts" section in the
Cisco MDS 9000 Family CLI Configuration Guide.
If you are running the switch setup utility for the first-time, it starts automatically. If this is not
the first-time configuration, you are required to enter setup at the system prompt.
If you do not wish to answer a previously configured question, or if you wish to skip answers to
any questions, press Enter. If a default answer is not available (for example, the switch name),
the switch uses what was previously configured and skips to the next question.
Chapter 2
6 2003 22:19:14 Copyright (C) 2002
| Low Memory
| Extended Memory
| ROM Shadowing
Initial Switch Configuration
|
: 630KB |
: 1018MB |
: Enabled |
OL-8251-01