Mercedes-Benz R 350 BlueTEC 2012 Operator's Manual page 64

Children in the vehicle
62
X
Pull release loop : in the direction of the
arrow.
X
Fold seat backrest ; forward in the
direction of seat cushion = until Top
Tether anchorage ? is accessible.
X
Route Top Tether belt B under the head
restraint between the two head restraint
bars.
X
Hook Top Tether hook A of Top Tether belt
B into Top Tether anchorage ?.
Ensure that:
Top Tether hook A is hooked into Top
R
Tether anchorage ? as shown
Top Tether belt B is not twisted
R
Top Tether belt B is routed between the
R
seat backrest and the cargo
compartment cover if the cargo
compartment cover is installed.
Top Tether belt B is routed between the
R
seat backrest and the cargo net if the
cargo net is installed.
X
Swing back the seat backrest until it
engages audibly (
G
WARNING
Always lock the rear seat backrests in their
upright position when the rear seats are
occupied by passengers. Lock the rear seat
backrests in their upright position after
installing the TopTether straps or when the
extended cargo compartment is not in use.
Make sure that rear seat backrests are
secured properly by pushing and pulling on
the seat backrests. If the seat backrest is not
locked properly, the seat backrest could fold.
The child restraint system is no longer
supported properly or held in position and can
no longer fulfill its function. That could cause
serious or even fatal injuries.
X
Move the head restraint back down again
slightly if necessary (
sure that you do not interfere with the
correct routing of Top Tether belt B.
X
Install the LATCH-type (ISOFIX) child
restraint system with Top Tether. Comply
with the manufacturer's installation
instructions when doing so. Make sure that
Top Tether belt B sits taut.
I n f o r ma t i o n P r o v i d e d b y :
Y page 253).
Y page 100). Make