Introduction - Powermatic PM2020 Operating Instructions And Parts Manual

29. Do not stand on the machine. Serious injury
could occur if the machine tips over.
30. Never leave the Lathe running unattended.
Turn the power off and do not leave the
machine until it comes to a complete stop.
31. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
32. Check the workpiece carefully for splits, knots
or other obstructions which may cause a
safety risk while turning.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly
even death.

4.0 Introduction

This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Model
PM2020 Lathe. This manual contains instructions on installation, safety precautions, general operating
procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed
to provide consistent, long-term operation if used in accordance with instructions set forth in this manual. If
there are any questions or comments, please contact either your local supplier or Powermatic. Powermatic can
also be reached at our web site: www.powermatic.com.
Register your product using the mail-in card provided, or register online:
http://www.powermatic.com/us/en/service-and-support/product-registration/
33. Adjust the tool support to the proper height
and position
workpiece by hand to check clearance with the
tool support.
34. Select the appropriate speed for the turning
job at hand. Start at low speed and allow the
Lathe to ramp up to operating speed.
35. Never stop a rotating workpiece with your
hand.
36. If gluing up a workpiece, always use a high-
quality glue of the type necessary for that
particular workpiece.
5
for the work. Rotate the