Creating A Target Binding Table - Fujitsu l ETERNUS AF Configuration Manual

Chapter 4 Setting Up the Server
4.3

Creating a Target Binding Table

4.3 Creating a Target Binding Table
This procedure is not necessary for direct connections.
Target binding logically binds the Fibre Channel card installed in the server, and the CA on the ETERNUS
DX/AF storage systems to be connected to the server. Target binding binds the instance name of the Fibre
Channel card, channel adapter name, WWN, and target ID.
1
Reflect the information from the "WWN instance management table for storage system" in the "target
binding table" (provided in
Target Binding Table
Server name: Server#0
Channel Adapter name SCSI T-ID
CM0CA0Port0
CM1CA0Port0
Name of target server
•
Each "channel adapter name" and "T_ID" entered in
•
for Storage System" (page 12)
The alias name entered in
•
(page 12)
2
Confirm the connection path(s) in the system.
Example:
Fibre Channel Switch A
CA0 Port0
Physical slots on Server#0 and CAs on the ETERNUS DX/AF storage systems are connected in the follow-
ing paths.
• Server#0 SLOT0 - CM0CA0
• Server#0 SLOT1 - CM1CA0
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
"Appendix A Various Management Table Templates" (page
DX400_CM0CA0P0
0
DX400_CM1CA0P0
0
"4.2 Creating a WWN Instance Management Table for Storage System"
Server#0
Slot0 Slot1
Fibre Channel Switch B
CA0 Port1 CA0 Port0 CA0 Port1
CM0 CM1
ETERNUS DX/AF
Copyright 2017 FUJITSU LIMITED
Alias name (WWN) Instance name
"4.2 Creating a WWN Instance Management Table
13
25)).
P3AM-3712-15ENZ0