SONIQ QPi600B Instruction Manual page 10

Setup and Connections
C. CONNECTING TO A DISPLAY (Using a HDMI cable)
For TVs that support it, HDMI can provide the best quality audio and video output (depending on media source),
and so is the preferred connection type. The HDMI cable incorporates both audio and video signals, so you will
have just one cable running from the unit to your TV.
Using the HDMI cable (not included), connect the HDMI OUT jack on your unit to the HDMI IN jack on your TV
or HDMI-compatible display.
• When using the HDMI cable, do not connect to other analog video outputs.
• Set an output signal from the HDMI terminal of the DVD player in accordance
with your TV's input signal.
• When using HDMI cable, set the HDMI Audio to PCM.
• Press the HDMI button on the remote control in DVD mode to change output signals as below:
480p/576p (progressive)
720p (progressive)
1080I (interlace)
1080p (progressive)
Note :
• Refer to your Instruction manual to the connected TV as well.
• When you connect the DVD player to your TV, be sure to turn off the power and unplug both units from the
wall outlet before making any connections.
• If you have a HDMI (with HDCP) equipped monitor or display, you can connect it to this player using a HDMI cable.
• It is not recommended to use a HDMI cable longer than 2 meters which may lower the HDMI performance.
CONNECTING TO OPTIONAL EQUIPMENT (AMPLIFIER)
A. ANALOGUE CONNECTION
Using an audio/video cable, connect the left/right
AUDIO OUT jack on your unit to the AUDIO IN jack
on your other source.
ANALOGUE CONNECTION
Amplifier of
stereo system, etc.
Audio cable
(red and white)
DRC300i
AUDIO IN
HDMI, the HDMI logo and High-Definition
Multimedia Interface are trademarks or
registered trademarks of HDMI licensing LLC.
B. DIGITAL CONNECTION
Using the Optical cable or Coaxial cable to connect to
a Dolby Digital receiver or decoder. Some receivers
have either the Coaxial or Optical type of digital audio
input jack and some have both.
• If connected to a DTS receiver through DIGITAL
OUT and DTS track is selected, there will be no
sound.
• When connecting the optical audio digital cable,
remove the protection cap from the connector and
connect it firmly. Keep the protection cap when the
connector is not in use to keep it dustfree.
DIGITAL CONNECTION
optical or coaxial input jack
Optical Digital
cable
(not included)
- 9 -
Audio equipment with
Coaxial Digital
OR
cable
(not included)