LG 32LH240H Owner's Manual page 93

Warning: Do not use LT2002 while any PPV card is
installed in TV or clone programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, use a paper clip or simi-
lar instrument inserted through the small hole marked "RESET"
to activate the internal reset switch and restore normal opera-
tion. After a reset, check the real-time clock setting. It may be
necessary to reset the Clone Programmer clock from a TV con-
taining the correct time.
Clone Programmer Troubleshooting
Problem
Clone Programmer
Clone copies Setup in
less than 30 seconds
Remote does not
operate clone.
LED does not blink.
Clone menu hard
to read.
No time set.
Clone not working.
Clone Scans Channels
more than once.
Master and Other TVs
Cloning did not work.
Clone time disappeared.
New Setup not present.
• After cloning operations are complete, just unplug the LT2002 from the TV.
• If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
206-4118
Reference: LT2002 Cloning Procedure Troubleshooting
Possible Cause(s)
• Not enough time to copy
entire TV setup.
• Wrong Installer remote.
• M.P.I. cord not connected.
• TV not turned on.
• Weak batteries.
• Weak signal.
• Time not available.
• Clone programmer
problem.
• Clone should only scan
channels once.
• Procedure interrupted.
• Different TV models.
• Step(s) omitted or
not performed.
• Batteries were removed.
• TV not reset.
Note
The LT2002 programmer is designed to be used with TVs con-
taining the 221-01006 and later processors. Use with earlier TV
sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use
the printed menu illustrations on the quick setup sheet sup-
plied with the Clone as an aid to making your programming
choices. (Although the menus are not all displayed, the clone
functions all operate normally.)
Possible Solution(s)
- Press Reset on clone programmer, redo teach/learn.
(Teach/Learn should take a minimum of 1 minute.)
- Only use an LG Installer remote to operate clone programmer
with TV.
- Connect M.P.I. cord properly, assure good connection.
- TV must be powered On for clone to work.
- Install 4 fresh AA high-quality alkaline batteries.
- Connect TV to a reliable Analog channel signal
source.
- Set time on a TV, copy time to Clone Programmer.
- Try a different LT2002 Clone programmer.
- Reset Clone Programmer.
- Retry cloning again.
- Wait until procedure complete message is displayed.
- Cloning is only possible with identical model TVs.
- Reread pages 7-8-9 to be sure all tasks were performed.
- Batteries must remain installed to retain time settings.
- Disconnect newly-cloned unit from power for 5 seconds.
P A G E 4 1