Media Elevator Car Location; Belt Block Bracket Access Cutout - HP StorageWorks MSL6000 Series Reference Manual

Figure 14

Media elevator car location

3. Insert a large paper clip through the holes on the idler pulley base to set the idler pulley tension
to zero. (See Figure 19
4. Turn the PTM over to access to the belt block bracket access cutout (see
CAUTION: To prevent damage to the PTM media elevator car, it must be supported from
underneath any time you are performing procedures on the belt block bracket assembly.
5. Remove one screw from each of the two belt block brackets. Loosen the other screw and move
each belt block bracket to the side to gain access to the drive belt (see
Figure 15

Belt block bracket access cutout

on page 28.)
MSL6000 series pass-through mechanism reference guide
Figure 15 on page 25).
Figure 15 on page 25).
25