ITF Ramp Motor Removal
Step #1
ITF ACCESS PLATE
Remove
** With the ramp in and passenger slider door
open.
A) Remove the 4 bolts securing the ITF motor
access plate using: T27 torx bit.
Step #3
Slide Ramp
Out
A
SPACERS
A) Lift up on the roller plate and slide the ramp
out slightly to gain access to the chain
anchor.
B) Remove spacers (set aside).
Step #5
B
A) Remove the 4 limit switch screws and
remove switches from motor housing.
B) Remove the (5) 1/4" mounting nuts for the
motor using a 7/16" socket w/ extension.
ITF Ramp Motor Removal
B
A
Page 45
ITF MOTOR
A) Remove the 2 allen bolts that attach the
roller plate to the chain anchor using a 5/32"
allen bit.
Master Link
A
A) Remove the master link closest to the gear,
then disconnect the anchor from the chain.
B) Pull the chain out of the motor
housing.
A) Unplug the connector for the motor and
remove motor from van.
*Install new motor in reverse order.
Step #2
Remove
ROLLER PLATE
Step #4
B
Step #6
A