INSTALLING THE MODBUS CARD
Installing the Modbus Card into an X-Slot
To prevent electrostatic discharge (ESD), place one hand on an unpainted metal surface such
as the UPS rear panel.
1.
NOTE Some UPSs may have another X-Slot module already installed (such as the
Powerware 9125 UPS). If there is a communication cable attached to this module, disconnect
the cable and then remove the X-Slot module.
2.
6
EATON Powerware
Remove the X-Slot cover (or existing X-Slot module) on the UPS
rear panel. Retain the screws (see Figure 5).
Figure 5. Removing the Single-Port Module
Install the Modbus Card into the X-Slot on the UPS.
Align the Modbus Card with the slot guides and slide the card into
the slot until it is firmly seated.
Secure the Modbus Card with the screws removed in Step 1.
®
®
S
Modbus
Card User's Guide
164201376 Rev C www.powerware.com
C A U T I O N