Plugging In Your Device - Kensington PilotMouse Wireless User Manual

72216_901056000print.qxd 3/3/2004

Plugging In Your Device

USB Connector
Turn off your computer before
plugging in ANY PS/2 device.
1
9:44 AM Page 2
PS/2 Connector
Warranty Information (continued)
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio com-
munications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may void the user's
authority to operate the device under FCC regulations and must not be made.
SHIELDED CABLES: In order to meet FCC requirements, all connections to equipment using a
Kensington input device should be made using only the shielded cable provided.
Declaration of Conformity Compliance Statement for the
Kensington PilotMouse
The Kensington PilotMouse Wireless (72216) complies with Part 15 of the FCC Rules.
Operation is subject to two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation. As defined in Section 2.909 of the FCC Rules, the responsible party
for this device is Kensington Technology Group, 2000 Alameda de las Pulgas, Second Floor, San
Mateo, CA 94403, (650) 572-2700.
10