Download Print this page

Before You Can Talk; Belt Clip - Motorola FR50 Instruction Manual

Hide thumbs Also See for FR50:

Advertisement

Applicant: Motorola Inc
Let's Talk About Your New Radio
Motorola FR50 radios operate on Family Radio Service (FRS) designated frequencies. This license-free, short range,
two-way radio service was established specifically for family and group recreational use. You can use your radios
anywhere within the United States and other areas listed by the FCC. Contact the FCC for more information.
Batteries
FR50 radios operate with 3 AA alkaline batteries providing approximately 30 hours of use. That's about 3 hours of
talk and 27 hours of standby time.
To Install:
1.
With the back of the radio facing you, flip the battery door clip down to release door.
2.
Lift door off.
3.
Insert 3 AA batteries making sure the plus signs are aligned on batteries and in the battery chamber.
4.
Replace the battery cover.
5.
Reposition the battery door clip and snap into place.
Low Battery Alert:
When batteries are low, the radio will chirp 1 to 2 seconds after turning power on, every 10 minutes, and
after release of the Push-To-Talk button. Replace the batteries immediately to avoid interrupted use.
Note: Remove batteries before storing your radio for extended periods. Batteries corrode over time and may cause
permanent damage to your radio.

Belt Clip

Motorola FR50 radios come standard with a belt clip.
To Attach:
1.
Locate the belt clip attachment opening on the radio's back.
2.
Align the belt clip with the grooves in the radio back.
3.
Gently push up until it clicks into place.
To Remove:
1. Grasp radio firmly.
1. Pull belt clip up and off the radio back.

Before You Can Talk

Read this manual carefully, make sure you know how to properly operate the radio before use.
Motorola FR50 radios have 14 channels. To talk to others, all radios in your group must be set to the same
channel (see charts in "Appendix A").
Turn the Radio On:
1.
Rotate Power/Volume knob until you hear a click. The radio will beep to confirm. The display will show
the current channel.
2.
To turn radio off, Rotate Power/Volume knob until you hear a click and display disappears.
Set the Channel
1. Turn the radio on.
1. Press Menu button. Current channel will begin to flash.
FCC ID: AZ489FT4832

Advertisement

loading