Epson RIP Station 5100 Administrator's Manual page 45

3
3-11 Network Setup options
For this Network or
Connection Type:
AppleTalk over Ethernet
TCP/IP over Ethernet
IPX/SPX over Ethernet
Parallel
T N
O ACCESS
1. Confirm that the network cable is connected to the RIP Station.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
5. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu, and
6. When you have finished entering port settings, choose Exit Port Setup and then choose
7. Enter the appropriate settings for the protocol or protocols you will use.
The available network types and relevant Setup areas are summarized in the following
table. The Setup options are described in detail in the following pages.
Use this Port Setup:
Ethernet Setup AppleTalk Setup
Ethernet Setup TCP/IP Setup: Ethernet Setup
Ethernet Setup IPX/SPX Setup
Parallel Port Setup
S :
ETWORK ETUP OPTIONS
During Network Setup, the RIP Station queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
appropriate settings.
enter the appropriate settings.
Protocol Setup.
Use this Protocol Setup:
—
Use this Service Setup:
AppleTalk printing (PAP) is
enabled automatically.
LPD Setup
Web Services Setup
Windows Setup
PServer Setup (NDS,
Bindery, or both)
—