Installation; Step 1 - Attach The Base - Gateway EV500 Manual

Installation

Use the following steps to install your monitor. If you are setting up
your system for the first time, refer to the setup poster for more
information about connecting additional peripherals.

Step 1 - Attach the Base

your monitor comes with a tilt/swivel base, which is shipped separate
from the monitor. Install the base as follows:
1. Carefully set the monitor on its side with the bottom of the
monitor facing you.
2. Hold the base so that the narrow end is pointed toward the back
of the monitor.
3. Align the four hooks on the bottom of the base with the
corresponding slots on the bottom of the monitor.
4. Slide the base toward the rear of the monitor so that all hooks are
securely in place. A retaining latch built into the bottom of the
monitor clicks into place when the base is correctly attached.
5. Carefully set the monitor upright and place the monitor on a
sturdy, even surface.
EV500-u5.p65 5
Installation
5
1999/9/16, PM 05:41