Asus N3050I-CM-A Manual page 11

Flat panel display brightness connector (8-pin
LCD_BLKT_PANEL)
This connector is for the LCD panel backlight and
brightness controls. It enables the LCD panel
backlight, provides backlight control signals, and
provides brightness control signals for the brightness
button on the front panel.
Intel
®
The motherboard comes with an onboard Intel
RTC Battery header (2-pin BATT_CON)
This connector is for the lithium CMOS battery.
WLAN module slot (WLAN)
Install a WLAN module into this slot.
Display panel VCC power selector (VCC_PWR_SEL)
1 (Default)
DDR3 DIMM slots
Install 2 GB, 4 GB, and 8 GB unbuffered non-ECC DDR3 DIMMs into these DIMM
sockets.
GPIO connector (10-pin GPIO_CON)
This GPIO (general purpose input/output) connector is a very
flexible multi-purpose interface that can be used to connect a
variety of simple one- or two-wire devices. It is a generic pin on an
integrated circuit or computer board whose behavior—including
whether it is an input or output pin—is controllable by the user at
run time.
TPM connector (14-1 pin TPM)
This connector supports a Trusted Platform Module (TPM) system,
which can securely store keys, digital certificates, passwords and
data. A TPM system also helps enhance network security, protects
digital identities, and ensures platform integrity.
1-4
Celeron Dual-core N3050 Processor
®
Pins
2
3
Celeron
®
Setting
3V
5V
12V
LCD_BLKT_PANEL
PIN 1
Brightness_Down
Brightness_up
BKLT_GND/Brightness_GND
BKLT_GND/Brightness_GND
BKLT_PWR
BKLT_PWR
BKLT_PWM
BKLT_EN
Dual-core processor.
®
BATT_CON
VCC_PWR_SEL
1
3V 5V
(Default)
GPIO_CON
TPM
Chapter 1: Product introduction
VBAT
GND
PIN 1
3
2
12V
PIN 1
PIN 1