Assembly/Pre-Operation・・・・・・・・・・・・・・・・・16; Pre-Operation・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・16; Operation ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・17 - Echo DHC-30 Operator's Manual

Table of Contents

Advertisement

16
A
SSEMBLY /
NOTE: The battery is preassembled in the knapsack for your convenience. Follow instructions under
"Pre-Operation" for charging the battery before use.
PRE-OPERATION
Charging --
WARNING
Always use the battery and charger supplied with the unit or
replacements approved by ECHO, KIORITZ
Using the wrong charger, especially an auto battery charger,
can result
battery damage or serious personal injury.
in
IMPORTANT: Charge the battery before and after use. Do not
charge Hedge Clipper in rain or wet locations. Avoid charging
battery when temperature or humidity is high. Do not charge battery
for more than 24 hours. It will reduce the life of the battery.
After extended, heavy use or after 4 to 5 years of average use,
battery will have to be recharged more and more often and will
need to be replaced.
Do not recharge battery in a confined or un-vented area. Do not smoke, strike a match or cause
a spark in the vicinity of the battery during charging. Operator injury may result.
NOTE: It is normal for the battery and charger to be warm during
charging.
Before charging battery. The battery is detached from battery case.
1. Carefully, connect each code clips (+)(-) of charger to battery
terminal.
2. Plug Charger into 220V~240V AC electrical outlet.
3.Indicator lamps (LED-O, LED-G) lights up when plug of charger is
inserted in outlet.
NOTE: Charge Indicator Lamps (LED-O & LED-R) shows that
charging has started.
4.Indicator lamps (LED-R & LED-O) light up while charging it.
5.When charge indicator lamp(LED-R) goes out and indicator lamp
(LED-G) light up, charging is complete. Disconnect charger from
outlet and from battery.
Complete charging depends on amount of use (3 - 3.5 hours).
※ Indicator lamps (LED-R):RED・・・・・・Charging
Indicator lamps (LED-G):GREEN・・・・Charging is complete
Indicator lamps (LED-O):ORANGE・・Power
6.After charging is completed, put the battery into the battery case.
7.Attach the connector from the battery to the one from the battery case.
P
O
RE-
PERATION
DANGER
WARNING
CORPORATION.
DANGER
CLIP BLACK ( - )
CLIPRED ( + )
Indicator LED-R
Indicator LED-G
Indicator LED-O

Advertisement

Table of Contents
loading

Table of Contents