Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
WARNING:
TO AVOID SERIOUS
INJURY, BEFORE PERFORMING
ANY SERVICE OR ADJUST-
MENTS:
Depress clutcWbrake
pedal fully and set parking brake.
Place gearshift lever in neutral (N) position.
Place attachment clutch in "DISENGAGED"
position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
(See Fig. 15)
Mower will be easier to remove from the right side of
tractor.
•
Place attachment
clutch in "DISENGAGED"
posi-
tion.
•
Move attachment lift lever forward to lower mower to
its lowest position.
•
Roll belt off engine pulley.
Remove small retainer spring,
and remove clutch
spring off pulley bolt.
•
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
•
Disconnect anti-swaybar from chassis bracket by re-
moving retainer spring.
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED
ON THE TRAC-
TOR, REMOVE THE FRONT LINKS AND HOOK THE
CLUTCH SPRING INTO SQUARE HOLE IN FRAME.
TO INSTALL
MOWER
(See Fig. 15)
•
Raise attachment lift lever to its highest position.
Slide mower under tractor with deflector shield to right
side of tractor.
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs.
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-swaybar to chassis bracket and secure
with retainer spring.
•
Push clutch cable housing guide into bracket, slide collar
onto guide and secure with large retainer spring.
Place flat washer and clutch spring on idler pulley bolt
and secure with small retainer spring.
•
Install belt onto engine pulley.
FLATWASHER
CLUTCH SPRING
SMALL RETAINER SPRING
RETAINER SPRINq
FRONT UNK
AN_-SWAY
BAR
RETAINER SPRINGS
(BOTH SLOES)
HOUSING GUIDE
LARGE RETAINER
SPRING
BRACKET
DEFLECTOR SHIELD
FIG. 15
19
Advertisement
Table of Contents
Troubleshooting
