Advertisement
Quick Links
O44JA311M O44JA311R
USER'S GUIDE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the party
responsible for compliance could void the user's authority
to operate this device.
INTRODUCTION
Thank you for choosing CompuStar, a state-of-the-art
TWO WAY alarm system for your vehicle. We, at
Firstech, Inc., are constantly researching and developing to
make you and your vehicle safe and more comfortable.
SECURITY & COMFORT, that's what Firstech, Inc. is all about.
TABLE OF CONTENTS
Operation: Remote Functions --------------------- page 3
Operation: LCD in remote ------------------------ page 6
Valet Mode ----------------------------------- page 6
Alarm Trigger -------------------------------- page 8
Transmitter Learning Procedure ------------------ page 9
Programming Options with Remote --------------- page 10
Limited Lifetime Warranty ---------------------- page 12
Registration Card ------------------------------ page 15
OPERATION: REMOTE FUNCTIONS
Please take time to read the owners manual. If you
have any question, please contact your authorized dealer.
Also, refer to the FUNCTION printed on the back of your remote.
Advertisement
Summary of Contents for CompuSTAR O44JA311M
- Page 1 INTRODUCTION Thank you for choosing CompuStar, a state-of-the-art TWO WAY alarm system for your vehicle. We, at Firstech, Inc., are constantly researching and developing to make you and your vehicle safe and more comfortable.
- Page 2 Button I. Press 1/2 sec. for Arm(Lock)/Disarm(Unlock) ARM: 1 chirp for confirmation. If there is no response, you are out of range. Upon arming, doors will lock (optional. see your dealer), LED will begin to flash, and the Starter Kill (Optional, see your dealer) will take into effect.
- Page 3 2. Door is open, 3. Trunk is open, 4. Vehicle is running and/or 5. Ignition Wire being powered. The LCD in the remote displays 5 different Modes Button I + II Press 1/2 sec. Mute mode (ON/OFF) ON, when SPK is not shaded in the LCD. OFF, when SPK is shaded in the LCD.
- Page 4 Alarm will be triggered in the following ways: 1. Light Impact will trigger the 1st stage of the Shock sensor; the siren will chirp 4 times and the parking lights will flash four times. The 1st stage will not page the Remote-Pager. 2.
- Page 5 Each time when you program a Remote, you have to program the 2nd or 3rd Remote also even if it was programmed previously. The parking lights will flash twice after 6 seconds. PROGRAMMING OPTIONS WITH REMOTE Step 1: Place the KEY in the Ignition and turn to ON position. Step 2: Press Button I+IV at the same time for 1/2 second.
- Page 6 product is defective Firstech, Inc, will at its option repair or replace such. "TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO, THE EXCLUSION OF ANY AND ALL WARRANTY OF MACHINABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OF ABROAD.