Troubleshooting Table; Operating Position; Operating Instructions - Poulan Pro 545123423 Instruction Manual

If the unit still doesn't start, refer to
TROUBLESHOOTING TABLE
1-800-554-6723.
OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . . . .
Brushcutter . . . . . . . . . . . . . . . . . .
Pruner . . . . . . . . . . . . . . . . . . . . . .
WARNING:
Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL AT-
TACHMENTS)
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
LOOSEN
Lower
Attachment
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Coupler
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
or call
MODEL:
PP1000E
PP2000T
PP3000B
WARNING:
PP4000C
release button is locked in the primary hole
PP5000P
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole

OPERATING INSTRUCTIONS

It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.

OPERATING POSITION

ALWAYS WEAR:
Knob
Long Pants
Heavy Shoes
Upper Shaft
Cut from your right to your left.
WARNING:
tion. Never lean over the trimmer head.
Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other
serious injury.
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
when the engine is run at less than full throttle.
At lower speeds, there is less engine noise
and vibration. The cutting line will last longer
and will be less likely to "weld" onto the spool.
Always release the throttle trigger and allow
the engine to return to idle speed when not
cutting.
10
Coupler Primary Hole
Guide Recess
Locking/ Attachment
Upper
Release
Shaft
Button
Make sure the locking/
Secondary Hole
Eye Protection
Always wear eye protec-