Table of Contents
Advertisement
UNPACKING CARTON (See Fig. 2)
CAUTION: Be careful of exposed staples
when handling or disposing of cartoning
material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLES.
•
While holding handle assembly, cut cable ties securing
handle assembly to top frame. Let handle assembly rest
on tiller.
•
Remove top frame of carton.
•
Slowly ease handle assembly up and place on top of
carton.
•
Cut down right hand front and right hand rear corners of
carton, lay side carton wall down.
•
Remove packing material from handle assembly.
HANDLE
ASSEMBLY
INSTALL HANDLE (See Figs. 3, 4, and 5)
•
Insert one handle lock (with teeth facing outward) in
gearcase notch. (Apply grease on smooth side of
handle lock to aid in keeping lock in place until handle
assembly is lowered into position.)
VIEWED FROM R.H. SIDE OF TILLER
HANDLE ASSEMBLY
ASSEMBLY
SHIFT ROD
FIG. 2
GEARCASE
NOTCH
HANDLE
LOCK
FIG. 3
•
Grasp handle assembly. Hold in "up" position. Be sure
handle lock remains in gearcase notch. Slide handle
assembly into position.
LOOSEN HANDLE
LOCK LEVER TO
MOVE
•
Rotate handle assembly down. Insert rear carriage bolt
first, with bolt head on L.H. side of tiller and loosely
assemble locknut (See Fig. 5).
•
Insert pivot bolt in front part of plate and tighten.
•
Cut down remaining corners of carton and lay panels flat.
•
Lower the handle assembly. Tighten nut on carriage bolt
so handle moves with some resistance. This will allow
for easier adjustment.
•
Place flat washer on threaded end of handle lock lever.
•
Insert handle lock lever through handle base and gearcase.
Screw in handle lock lever just enough to hold lever in
place.
•
Insert second handle lock (with teeth inward) in the slot
of the handle base (just inside of washer).
•
With handle assembly in lowest position, securely
tighten handle lock lever by rotating clockwise. Leaving
handle assembly in lowest position will make it easier
to remove tiller from carton.
GEARCASE
SLOT
REAR
CARRIAGE
BOLT
HANDLE
BASE
5
HANDLE ASSEMBLY
"UP" POSITION
TIGHTEN HANDLE
LOCK LEVER TO
HOLD
FIG. 4
HANDLE
HANDLE
LOCK
FLAT
LOCK
WASHER
LEVER
PIVOT
BOLT
LOCKNUT
FIG. 5
Advertisement
Table of Contents
