Chapter 4 Checking The Server Information - Fujitsu eternus dx Configuration Manual

Chapter 4
Checking the Server Information
The server information registered in the ETERNUS DX/AF should be checked.
A variety of commands are used to check the following server information.
iSCSI Software Initiator
•
Since iSCSI Software Initiator is provided with the OS, installation is not required.
Check the SUNWiscsiu and SUNWiscsir packages using the "pkginfo" command.
iSCSI Initiator name
•
The iSCSI Initiator name is required for the ETERNUS DX/AF settings.
Execute the following command to check the iSCSI Initiator name:
# iscsiadm list initiator-node
Initiator node name: iqn.1986-03.com.sun:01:0003bace9997.48a386c4
Initiator node alias: -
Login Parameters (Default/Configured):
Header Digest: NONE/-
Data Digest: NONE/-
Authentication Type: NONE
RADIUS Server: NONE
Configured Sessions: 1
The iSCSI Initiator name is displayed in the "Initiator node name" column.
Server-side LAN card IP address for connecting to the ETERNUS DX/AF
•
Execute the following command:
# ifconfig -a
Set this IP address if it is not already set.
• Initiator CHAP Name
The Initiator CHAP Name is the user name for unidirectional CHAP authentication. Execute the following
command:
This is not required if CHAP authentication is not used.
# iscsiadm list initiator-node
The Initiator CHAP Name is displayed in the "CHAP Name" column of the applicable target information.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (iSCSI) for Oracle Solaris
13
Copyright 2017 FUJITSU LIMITED
P3AM-4042-18ENZ0