Poulan Pro 188904 Owner's Manual page 9

Rear tine tiller
Table of Contents

Advertisement

Swing the handle in the opposite direction you wish
to turn, being careful to keep feet and legs away from
tines.
When you have completed your turn-around, release
the drive control bar and lower handle. Place shift
lever in till position and move throttle control to de sired
speed. To begin tilling, hold drive control bar against
the handle.
OUTER SIDE SHIELDS (See Fig. 11)
The back edges of the outer side shields are slotted so
that the shields can be raised for deep tilling and low ered
for shal low tilling to protect small plants from being buried.
Loosen nut "A" in slot and nut "B". Move shield to desired
position (both sides). Retighten nuts.
TO TRANSPORT
CAUTION: Before lifting or trans port ing,
allow tiller engine and muffl er to cool.
Disconnect spark plug wire.
gasoline from fuel tank.
AROUND THE YARD
Release the depth stake pin. Move the depth stake
down to the top hole for transporting the tiller. Place
depth stake pin in hole of depth stake to lock in posi-
tion. This prevents tines from scuffi ng the ground.
Place shift lever indicator in "F" (forward) position for
transporting.
Hold the drive control bar against the handle to start
tiller movement. Tines will not turn.
Move throttle control to desired speed.
AROUND TOWN
Disconnect spark plug wire.
Drain fuel tank.
Transport in upright position to prevent oil leakage.
BEFORE START ING ENGINE
IMPORTANT: BE VERY CAREFUL NOT TO ALLOW DIRT
TO ENTER THE ENGINE WHEN CHECKING OR ADDING
OIL OR FUEL. USE CLEAN OIL AND FUEL AND STORE IN
APPROVED, CLEAN, COVERED CONTAINERS. USE CLEAN
FILL FUNNELS.
CHECK ENGINE OIL LEVEL (See Fig. 12)
The engine in your unit has been shipped, from the
factory, already fi lled with SAE 30 summer weight oil.
With engine level, clean area around oil fi ller plug and
remove plug.
Engine oil should be to point of overfl owing when engine
is level. For ap proxi mate capacity see "PROD UCT
SPEC I FI CA TIONS" on page 3 of this manual. All oil
must meet A.P.I. Service Classifi cation SF-SJ.
Reinstall engine oil cap and tighten.
For cold weather operation you should change oil for
easier starting (See oil viscosity chart in the Mainte-
nance sec tion of this manual).
To change engine oil, see the Maintenance section in
this manual.
OPERATION
OIL
LEVEL
ADD GASOLINE
Fill fuel tank to bottom of fi ller neck. Do not overfi ll.
Use fresh, clean, regular un lead ed gasoline with a
minimum of 87 octane. (Use of leaded gasoline will
increase carbon and lead oxide deposits and reduce
valve life). Do not mix oil with gasoline. Purchase fuel
Drain
in quan ti ties that can be used within 30 days to assure
fuel freshness.
IMPORTANT:
BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE
GAS O LINE TO HELP INSURE GOOD COLD WEATHER
START ING.
CAUTION:
gas o hol or using ethanol or methanol) can at-
tract moisture which leads to sep a ra tion and
for ma tion of acids during storage. Acidic gas
can damage the fuel system of an engine while
in storage. To avoid engine problems, the fuel
system should be emptied before stor age of
30 days or longer. Drain the gas tank, start
the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel next
sea son. See Storage In struc tions for additional
information. Never use engine or carburetor
cleaner products in the fuel tank or permanent
damage may occur.
TO START ENGINE (See Fig. 13)
When starting engine for the fi rst time or if engine has run
out of fuel, it will take extra pulls of the recoil starter to
move fuel from the tank to the engine.
9
FIG. 12
CAUTION: Fill to within 1/2 inch of top
of fuel tank to prevent spills and to allow
for fuel expansion. If gasoline is ac-
ci den tal ly spilled, move machine away
from area of spill. Avoid creating any
source of ignition until gasoline vapors
have disappeared.
Wipe off any spilled oil or fuel. Do not
store, spill or use gasoline near an
open fl ame.
WHEN OPERATING IN TEMPERATURES
Alcohol blended fuels (called
CAUTION: Keep drive control bar in
"DISENGAGED" position when start-
ing en gine.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prrt65d

Table of Contents