Poulan Pro 428550 Owner's Manual page 9

GAS O LINE
FILLER
CAP
PRIM ER
CHOKE
CON-
TROL
SAFETY
IGNITION KEY
FUEL SHUT-OFF VALVE
THROTTLE
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle- used to se lect FAST or SLOW engine speeds.
Choke Control - used for starting a cold engine.
OPERATION
POWER
CORD
AUGER
PLUG
CONTROL
LEVER
ELECTRIC
START
BUTTON
DE FLEC TOR
DISCHARGE
CHUTE
CLEAN-OUT TOOL
FIG. 10
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-
pro pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di rec-
tion the snow is thrown.
Deflector remote control lever - used to change the
dis tance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
9
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CON TROL LEVER
CHUTE
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
SKID PLATE