Table of Contents
Advertisement
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
•
Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
•
If equipped, turn height adjustment knob clockwise to
remove slack from mower suspension.
•
Raise deck to highest position.
•
Adjust gauge wheels before operating mower as shown
in the Operation section of this manual.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
•
Reduce tire pressure to PSI shown in "PRODUCT
SPECIFICATIONS" section of this manual.
CHASSIS
BRACKET
GAUGE
WHEEL
DOUBLE LOOP
RETAINER SPRING
USE PLIERS FOR
RETAINER SPRINGS
LOOP DOWN
C HECKLIST
!
BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC-
TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE
BEST PERFORMANCE AND SATISFACTION FROM THIS
QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
All assembly instructions have been completed.
!
No remaining loose parts in carton.
!
Battery is properly prepared and charged. (Minimum 1
!
hour at 6 amps).
Seat is adjusted comfortably and tightened securely.
!
All tires are properly inflated. (For shipping purposes,
!
the tires were overinflated at the factory).
Be sure mower deck is properly leveled side-to-side/
!
front-to-rear for best cutting results. (Tires must be
properly inflated for leveling).
ASSEMBLY
ANTI-SWAY
BAR
SUSPENSION ARMS
DOUBLE LOOP RETAINER
SPRING (OUTWARD
POINTING DECK PINS)
FIG. 7
CHECK MOWER LEVELNESS
For best cutting results, mower should be properly leveled.
See "TO LEVEL MOWER HOUSING" in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual. Verify that the belts are
routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that
the brake is properly adjusted. See "TO ADJUST BRAKE"
in the Service and Adjustments section of this manual.
FRONT
SUSPENSION
BRACKETS
FRONT
MOWER
BRACKET
Check mower and drive belts. Be sure they are routed
!
properly around pulleys and inside all belt keepers.
Check wiring. See that all connections are still secure
!
and wires are properly clamped.
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
Engine oil is at proper level.
!
Fuel tank is filled with fresh, clean, regular unleaded
!
gasoline.
Become familiar with all controls - their location and
!
function. Operate them before you start the engine.
Be sure brake system is in safe operating condition.
!
9
ELECTRIC
CLUTCH
PULLEY
FRONT PLATE
ASSEMBLY
DEFLECTOR
SHIELD
Advertisement
Table of Contents
