Table Of Contents; Safety Rules; General Operation; Slope Operation - Poulan Pro PR600Y21RP Operator's Manual

Self-propelled rotary lawn mower
Hide thumbs Also See for PR600Y21RP:
Table of Contents

Advertisement

TABLE OF CONTENTS

Safety Rules ................. 2-3

Maintenance ............. 16-18
Assembly ...................... 4-7
Service and
Operation.................... 8-15
Adjustments.............. 19-24
SAFETY RULES
IMPORTANT: This cutting machine is capable of amputating hands and feet and throwing ob-
jects. Failure to observe the following safety instructions could result in serious injury or death.
Look for this symbol to point out im por -
tant safety precautions. It means
CAU TION!!! BECOME ALERT!!!
YOUR SAFE TY IS INVOLVED.
WARNING: In order to prevent ac ci den tal
starting when setting up, trans port ing, ad-
just ing or making repairs, always dis con nect
spark plug wire and place wire where it can not
come in contact with plug.
WARNING: Engine exhaust, some of its
constituents, and certain vehicle com po -
nents contain or emit chem i cals known to
the State of Cal i for nia to cause can cer and
birth defects or oth er re pro duc tive harm.
WARNING: Battery posts, terminals and
related accessories contain lead and lead
compounds, chemicals known to the State
of Cal i for nia to cause can cer and birth
defects or oth er re pro duc tive harm. Wash
hands after handling.
CAUTION: Muffl er and
other engine parts become
extremely hot during
operation and remain hot
after engine has stopped.
To avoid severe burns on
contact, stay away from these areas.
I. GENERAL OPERATION
• Read, understand, and follow all
in struc tions on the machine and in the
manual(s) before starting. Be thor ough ly
familiar with the controls and the proper
use of the machine before starting.
• Do not put hands or feet near or under
rotating parts. Keep clear of the dis-
charge opening at all times.
• Only allow responsible individuals, who
are familiar with the in struc tions, to oper-
ate the machine.
• Clear the area of objects such as rocks,
toys, wire, bones, sticks, etc., which
could be picked up and thrown by blade.
• Be sure the area is clear of other people
before mowing. Stop ma chine if anyone
enters the area.
• Do not operate the mower when bare-
foot or wearing open sandals. Al ways
wear substantial foot wear.
Storage ..................... 25-26
Troubleshooting ........ 26-27
• Do not pull mower backwards unless
absolutely nec es sary. Always look down
and behind before and while moving
backwards.
• Never direct discharged material toward
anyone. Avoid discharging material against
a wall or obstruction. Material may richo-
chet back toward the operator. Stop the
blade when crossing gravel surfaces.
• Do not operate the mower without
proper guards, plates, grass catcher or
oth er safety protective devices in place.
• See manufacturer's instructions for
proper operation and installation of
accessories. Only use accessories ap-
proved by the manufacturer.
• Stop the blade(s) when crossing grav el
drives, walks, or roads.
• Stop the engine (motor) whenever you
leave the equip ment, before clean ing the
mower or unclogging the chute.
• Shut the engine (motor) off and wait until
the blade comes to complete stop before
removing grass catcher.
• Mow only in daylight / good artifi cial light.
• Do not operate the machine while under
the infl uence of alcohol or drugs.
• Never operate machine in wet grass.
Always be sure of your footing: keep a
fi rm hold on the handle; walk, never run.
• Disengage the self-propelled mech-
a nism or drive clutch on mowers so
equipped before starting the engine.
• If the equipment should start to vi brate
abnormally, stop the engine (motor) and
check immediately for the cause. Vibra-
tion is generally a warning of trouble.
• Always wear safety goggles or safe ty glass-
es with side shields when op er at ing mower.
II. SLOPE OPERATION
Slopes are a major factor related to slip &
fall accidents which can result in severe in-
jury. All slopes require extra caution. If you
feel uneasy on a slope, do not mow it.
DO:
• Mow across the face of slopes: nev er
up and down. Exercise extreme caution
when changing direction on slopes.
2
TROUBLESHOOTING - See appropriate section in manual unless directed
to an authorized Service Center.
PROBLEM
CAUSE
Loss of power
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air fi lter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
Poor cut –
1. Worn, bent or loose blade.
uneven
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
Excessive
1. Worn, bent or loose blade.
vibration
2. Bent engine crankshaft.
Starter rope
1. Engine fl ywheel brake is on
hard to pull
when control bar is released.
2. Bent engine crankshaft.
3. Blade adapter broken.
4. Blade dragging in grass.
Grass catcher
1. Cutting height too low.
not fi lling
2. Lift on blade worn off.
(If so equipped)
3. Catcher not venting air.
Hard to push
1. Grass is too high or wheel
height is too low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
Loss of drive
1. Belt wear.
or slowing of
2. Belt off of pulley.
drive speed
3. Drive cable worn or broken.
4. "Loose" drive control system. 4. Adjust drive control.
CORRECTION
1. Raise cutting height.
2. Raise cutting height.
3. Clean/replace air fi lter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a qualifi ed service
center.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact a qualifi ed service
center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to suit.
1. Check/replace drive belt.
2. Check/reinstall drive belt.
3. Replace drive cable.
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents