Yamaha XVS1100AWR Service Manual page 12

A Fasten the handlebar switch
lead (left and right) to the handle-
bar with plastic locking tie and
cut the end of tie.
B Lay out the throttle and starter
cables in three rows and secure
them with a clip. (Two points at
the front and rear.) Care should
be taken at this time so that the
clip does not fall to the outside
against the vertical face of the
vehicle. Point the opening part of
the clip to the inside of the ve-
hicle.
CABLE ROUTING
C Clamp the wire harness with the
hook of frame side.
D When installing the pipe of
throttle cable press it inside.
E Clamp the fuel hoses to the
frame with the clamp.
F Cross the fuel hose (fuel cock
side) and fuel hose (carburetor
side) between guide of frame
and clamp. (carburetor side is
upper)
G When connecting the sensing
hose (carburetor joint to AI sys-
tem) with a nozzle.
–6–
SPEC
H Push the wire harness inside of
the side cover.
I Push the sensing hose inside of
the tool box plate and not bend
the sensing hose.
J Through the wire harness of so-
lenoid valve between AIS duct
and fuel hose (for CAL).
K Fasten the alarm lead with a plas-
tic band on the tool box plate.
L Fasten the sidestand switch lead
to the bracket of tool box plate
with plastic locking tie.