Cisco ASA 5508-X Quick Start Manual page 5

Cisco ASA 5508-X and ASA 5516-X Quick Start Guide
ASDM can change the ASA FirePOWER module IP address settings over the ASA backplane; but for ASDM to
then manage the module, ASDM must be able to reach the module (and its new IP address) on the
Management 1/1 interface over the network. The recommended deployment allows this access because the
module IP address is on the inside network. If ASDM cannot reach the module on the network after you set
the IP address, then you will see an error.
7. Choose Wizards > Startup Wizard.
8. Configure additional ASA settings as desired, or skip screens until you reach the ASA FirePOWER Basic
Configuration screen.
Set the following values to work with the default configuration:
— IP Address—192.168.1.2
— Subnet Mask—255.255.255.0
— Gateway—192.168.1.1
9. Click I accept the agreement, and click Next or Finish to complete the wizard.
10. Quit ASDM, and then relaunch. You should see ASA FirePOWER tabs on the Home page.
6. Run Other ASDM Wizards and Advanced Configuration
ASDM includes many wizards to configure your security policy. See the Wizards menu for all available wizards.
6. Run Other ASDM Wizards and Advanced Configuration
5