Recording / Playing Back Your Performance; Recording Your Performance - Korg concert A-4501 Owner's Manual

Recording / playing back your
performance
The A-4501 contains a b uilt-in recorder that lets you
record and playback your performance as easily as
using a tape recorder .
You can record your playing on tw o parts. These parts
can be played back simultaneously to create a single
song, or used to record tw o separate songs.

1. Recording your performance

Recording your performance
1. Press a [Sound selector] switch to select the
sound that you wish to record.
2. Press the [RECORD] switch.
The [RECORD] switch indicator will light.
3. Press either [PART 1] or [PART 2] to select the
part that you wish to record.
This will mak e the switch indicator blink red for
the part that you wish to record.
one of the parts in record-ready mode.
This part contains no
Dark
recorded data.
Ready to record. Recording
Blinking red
will occur on this part.
This part contains recorded
Lit green
data.
Playback is muted. Select
Blinking green
this state when you do not
wish to hear this part while
recording.
When there is no recorded data
Dark
Press switch
Ready to record
Blinking red
Press switch
4. Recording will begin when you press either the
MeMO
5. Press the [START/STOP] switch to stop record-
You can put only
When there is recorded data
Lit green
Press switch
Muted (silenced)
Blinking green
Blinking green
Press switch
Ready to record
Blinking red
Press switch
[START/STOP] switch, a note, or a pedal, or
when a MIDI message is received.
When the [ST ART/STOP] switch is pressed,
recording will be gin after a tw o-measure count.
During recording, the [ST ART/STOP] switch
indicator will blink in time with the time signature,
red on the f irst beat and green on other beats.
or
When Layer is being used, pedal settings will be
fixed at "Enable" for both sounds during recording.
Never turn of f the po wer during recording.
If you wish to record along with the metronome, you can
turn on the metronome ( ☞p.13).
ing.
If you press the [P AUSE] switch, recording will
pause at that location, and the [P AUSE] indicator
will light.
Press the [RECORD] switch, select the
[PART1(or2)], then play the k eyboard to resume
recording.
Recording will o verwrite the pre vious data, and the
pre viously-recorded data will be erased.
Recording may not al ways begin correctly from the
paused location.
When there is recorded data
(one part is ready to record)
Lit green
Blinking red
Press switch
Muted (silenced)
Blinking red
Press switch
or
17