Control Channel Configuration; Changing The Control Channel - Motorola WMC6300 User Manual

Chapter 4: MeshTray
Reporting Interval in seconds
IP Address of server to report
position to

Control Channel Configuration

There are four channels available for 2.4 GHz network communications. The Network Administrator
can map the four available Physical channels to three Data channels and one Control channel. The
Data channels will be used for data transmission between subscriber devices, infrastructure devices,
and the network. When the using the 2.4 GHz Wireless Modem Card (WMC), the Control channel is
designated for internal MEA communication. By default, it is set to the physical channel 3 (2.47 GHz).
When working with the 4.9 GHz WMC the available channels are 4.950, 4.955, 4.960, and 4.965.

Changing the Control Channel

A user should never change the channel mappings unless specifically instructed to do so by the
Network Administrator.
6881011Y52-O August 2005
Do not enter decimal point values as
they will be dropped after, the "Apply"
button is selected.
The reporting interval must be entered in seconds (up to a
maximum of 180 seconds) and is used for updating the Geo
Position tab data contents for longitude and latitude or X, Y, Z
positions for the Spherical Coordinate Use the Up arrow to set the
number of seconds.
This is the IP Address where the geo position is forwarded or
reported to. Typically, this is a centralized server that displays the
position of all devices on the network.
4-4