Quality Of Service On Gwn7000; Figure 2: Qos Page - Grandstream Networks GWN7000 User Manual

QUALITY OF SERVICE ON GWN7000

The GWN7000 supports 802.1Q, 802.1p Layer 2 standards allowing to create multiple traffic classes, filter
by port, IP address or network groups. Along with the support of DSCP Layer 3 marking and policing
features to help shape high downstream traffic.
QoS features are accessible from GWN7000's WebGUI Router QoS
To activate QoS, check "Enable QoS". Three tabs are available for configuration:
1. Global: To configure download and upload bandwidth speeds settings on each WAN interface.
2. Upstream QoS: Upstream QoS allows creating Traffic Classes to prioritize traffic for specific resources
on the network by controlling transmission/upload rate. Note that different traffic filters can be created
and applied to classes to mark the packet with the DSCP value by respecting following conditions:
✓ The total of Upstream bandwidth values of each created class should not exceed the upstream
bandwidth value configured in Global.
✓ The remaining bandwidth will be lent to the class of traffic with the next priority.
✓ All filter options are summed together.
3. Policer: While Upstream QoS is dealing with traffic transmission, Policer is controlling the incoming
traffic. Thus, allowing to create rules to specific targets to set priority and received traffic rate, giving the
GWN7000 the ability to drop the exceeding traffic when reaching the configured maximum rate.

Figure 2: QoS Page

QoS in VoIP Environment Guide
P a g e | 6