Table of Contents
Advertisement
Maintenance
INSPECT/TEST FUEL SUPPLY SYSTEM
Every three months (or 120 hours), an authorized operator should
inspect and test the fuel supply system, as well as all fuel system
connections. All connections must be tight and in good condition.
A loose fuel system line may show no signs of leakage, but may
draw air into the system causing rough operation and starting dif-
ficulties. Any defective or leaking component should be repaired or
replaced immediately by an Authorized Service Technician.
REPAIR PARTS
The latter portion of this manual consist of exploded views, parts
lists and electrical data pertaining to this generator set. The parts
lists consist of (a) an item number, (b) a part number, (c) the quan-
tity required, and (d) a description of the part. The item number
corresponds to an identical number on the exploded view drawing.
STATIONARY EMERGENCY GENERATOR SET XPL LABEL
Every generator set has a XPL LABEL affixed to the lower con-
nection box (Figure 4.1). Additionally, a printed CONSTRUCTION
DOCUMENT containing identical information can be found at the
end of this manual.
When requesting information, ordering replacement parts, asking
for service, etc., one or more of the following may be needed:
• Generator Model Number
• Date of Manufacture
• Generator Identification Code
• Generator Assembly Groups
Figure 4.1 — XPL Label
GENERAC POWER SYSTEMS
MODEL NO. 00A 00000 S
GROUP
DESCRIPTION
A
Generator
B
Control Panel
C
Mounting Base
D
Engine & Accy.
E
Fuel Systems
F
Compartments
G
Wiring Diagrams
H
Kits
WHEN ORDERING REPAIR PARTS,
ALWAYS GIVE THE ABOVE INFORMATION
16
DATE 00/00/06
(Generator ID Code)
ASSEMBLY NUMBERS
00000 00000
00000 00000 00000
00000 00000 00000
00000 00000
00000
00000 00000
00000 00000 00000
00000 00000
The above is a generic representation of a data card. For actual
information related to this particular model, please refer to the
"construction document" located at the end of this manual, or
to the data cards affixed to the unit.
HOW TO ORDER PARTS
To order a replacement part, locate the part in the applicable
exploded view. Contact an Authorized Service Dealer (call 800-
333-1322 to locate one in the area) and provide the following
information:
• The generator model number.
• The generator identification code, which indicates the specific
generator assembly for each unit.
• The part number and corresponding description from the appli-
cable parts list in this manual.
• The applicable exploded view "Group" letter (A-H) and draw-
ing number (five-digit number), which can be found on the
exploded view drawing.
In most cases, repair parts can be obtained by providing the
Authorized Service Dealer with the data label information and
a description of the required part. If unable to locate either
the data label or the construction document, describe the part
needed and provide the unit's model number. This number can
be found on the DATA LABEL attached to the generator's lower
connection box.
NOTE:
NOTE:
Advertisement
Table of Contents
