Changing Or Deleting An Observing Port; Establishing The Configuration Task; Optional) Deleting An Observing Port - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
If the following result is obtained, the configuration is successful:
The traffic policy applied on an interface is cancelled.

8.14 Changing or Deleting an Observing Port

This section describes how to change or delete an observing port.

8.14.1 Establishing the Configuration Task

Applicable Environment
When you do not need to monitor the flow passing through the S3700, you can delete the current
observing port; when you need to specify another interface on the S3700 as an observing port,
you can change the current observing port.
Pre-configuration Tasks
Before changing or deleting an observing port, complete the following tasks:
l
l
l
l
Data Preparation
To change or delete an observing port, you need the following data.
No.
1

8.14.2 (Optional) Deleting an Observing Port

Prerequisite
Before deleting an observing port, make sure that the observing port is not used in any mirroring
configuration.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
Issue 01 (2011-07-15)
8.4 Canceling Port Mirroring
8.7 Canceling VLAN Mirroring
8.10 Canceling Mirroring Based on MAC Addresses
8.13 Canceling Flow Mirroring
Data
Type and number of the new observing port
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Mirroring
100