Table of Contents
Advertisement
XP40-Q1942 Explosion-Protected PT Network Camera
Technical specifications
Technical specifications
To find the latest version of the datasheet, go to www.axis.com > product > Support & Documentation.
LED Indicators
Status LED
Unlit
Green
Amber
Amber/Red
Red
SD card slot
NOTICE
NO
NO
TICE
TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects, or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the product's webpage before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Buttons
Control Button
For location of the control button, see Product overview on page 7 .
The control button is used for:
•
Resetting the product to factory default settings. See page 53.
•
Connecting to an AXIS Video Hosting System service. See page 45. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 45. To connect, press and hold the button for about 3 seconds.
Performance considerations
When setting up your system, it is important to consider how various settings and situations affect the performance. Some factors
affect the amount of bandwidth (the bitrate) required, others can affect the frame rate, and some affect both. If the load on the
CPU reaches its maximum, this also affects the frame rate.
The following factors are the most important to consider:
•
High image resolution or lower compression levels result in images containing more data which in turn affects the
bandwidth.
•
Access by large numbers of Motion JPEG or unicast H.264 clients affects the bandwidth.
Indication
Connection and normal operation.
Connection and normal operation.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
Firmware upgrade failure.
58
Advertisement
Table of Contents
