Installing The Software - Panasonic CF-U1G Supplementary Instructions Manual

Installing the Software

Installing the Software
The steps below must be taken before using the HSPA modem.
1
<Only for CF-H1/CF-U1 series>
Turn off the computer and set the computer to the Cradle.
<Only for CF-C1 series>
Turn off the computer and set the computer to the Port
Replicator.
2
<Only for CF-H1/CF-U1 series>
Connect the CD/DVD drive and an external keyboard to
the Cradle.
<Only for CF-19 series>
Connect the CD/DVD drive to the computer.
3
Turn on the computer, and run the Setup Utility by
pressing
displayed.
If [Enter Password] is displayed, input the Supervisor Password.
4
Select the [Advanced] - [Wireless Confi guration] menu,
and set [Wireless WAN] to [Enabled].
5
Save the settings and exit the Setup Utility.
6
Log on to Windows as an administrator.
If the [Found New Hardware Wizard] screen is displayed, click [Cancel] to
close the screen.
7
Install the Wireless WAN software by following
procedures.
A Set the Wireless WAN (HSPA) Software CD-ROM into the CD/DVD
drive.
B Follow the on-screen instructions, and install the Wireless WAN
Software Installer.
If the installer does not start up, proceed as follows to install the Wireless
WAN software.
Click (Start) and enter "x:*
and fi les], and press Enter .
or while [Panasonic] boot screen is
F2 Del
\gb2kpack\setup.exe" in [Search programs
1
3