Samsung SPH-A460 User Manual page 18

When you're ready to charge your battery, it is vital that you use only Sprint PCS-approved desktop
chargers and travel chargers. To use the desktop charger provided with your phone:
Plug the power cord of the charger into a wall outlet.
1.
There are three possible charging configurations.
2.
Choose the one that best suits your needs:
Insert the phone (with the battery installed) into the front slot of the charger.
_
Insert a single battery (alone, not attached to the phone) into the rear compartment of the charger.
_
Insert a single battery into the rear compartment and your phone (with battery attached) into the
_
front compartment.
The LEDs on the front of the charger indicate the following:
A on the charger lets you know the battery is charging.
red light
_
A lets you know that the battery is at least 90 percent charged.
green light
_
A indicates that the battery is operating at a temperature that is too high or too low, or
yellow light
_
that there is a poor connection. Check the phone to make sure it is properly positioned in the charger.
It generally takes about 3 hours to fully recharge a completely discharged battery. With the Sprint
PCS-approved Lilon battery, it is okay to recharge the battery before it becomes completely run
down.
To get the quickest charge for any battery:
Turn the phone off.
_
Put the phone with the battery attached, into the front slot of the charger.
_
Do not put a battery into the rear slot of the charger.
_
When two batteries are in the charger, the batteries charge simultaneously, but charging time
_
increases for both batteries.
Leaving batteries in the charger once fully charged will not hurt the batteries.
_
4
Entering Text
17