Page 1
Demolition Hammer 2100W Model CT4001 ORIGINAL INSTRUCTION CAUTION: Safety Before using this Instructions Demolition Hammer or Assembly any of its accessories, Operation read this manual and Maintenance follow all its Safety Rules Parts List and Operating...
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: Demolition Hammer Model: CT4001 Applicable EC Directives: ●EC-Machinery Directive 2006/42/EC ●EC-Directive on electromagnetic compatibility(EMC)2004/108/EC...
SPECIFICATIONS TECHINCAL CHARACTERISTICS CT4001 Voltage/Frequency: 230V/50Hz Rated input:2100W Impact hammer action: 1600Bpm Protection against electric shocks of class Ⅱ Weight kg Level of sound pressure according to EN ISO 4871 measured (sound pressure level) =85.09 dB(A) (sound power level) K=3,0dB(A)
POWER TOOL SAFETY GENERAL SAFETY RULES If operating a power tool in a damp WARNING location is unavoidable, use a residual current device (RCD) protected supply. all safety warnings and Read Use of an RCD reduces the risk of electric instructions.
Page 5
POWER TOOL SAFETY ensure that the safety of the power tool is POWER TOOL USE AND CARE maintained. Do not force the power tool. Use the When servicing a tool, use only identical correct power tool for your application. replacement parts. Follow instructions in the The correct power tool will do the job better Maintenance section of this manual.
POWER TOOL SAFETY SPECIFIC SAFETY RULES – cont’d SYMBOLS TO AVOID INJURY from accidental starting, always remove the Plug from the electrical socket before installing or Some of the following symbols may be removing a drill bit, accessory or used on your tool.
ACCESSORIES & CARTON CONTENTS CARTON CONTENTS – cont’d AVAILABLE ACCESSORIES WARNING no CT4001 DESCRIPTION Demolition Hammer Use only accessories recommended for this Demolition hammer. Follow SDS Chisels instructions that accompany accessories. Use of improper accessories may cause injury to the operator or damage to the Oil pot Demolition hammer.
ASSEMBLY & OPERATION WARNING Always make sure the power tool is isolated from the power supply before fitting any attachment FUNCTIONAL DESCRIPTION CAUTION: This tool accepts bits either with or Always be sure that the tool is switched without a collar on its shank. off and unplugged before adjusting or To install the bit, follow either procedure (1) or (2) described below.
ASSEMBLY & OPERATION damage from various types of commercial Pull out and turn the tool retainer 180 solvents and may be damaged by their use. Use clean cloth to remove dirt, dust, oil, degrees to secure the bit. grease etc. To remove the bit, follow the WARNING installation procedure inreserve.
Page 11
MAINTENANCE When the resin insulating tip inside the Hammer is used continuously 3~4 hours carbon brush is exposed to contact the daily. Feed oil into the oil tank as described commutator, it will automatically shut off below before using this Hammer. Just the motor.
Page 13
PARTS LIST WARNING When servicing, use only identical replacement parts. Use of any other parts may create a HAZARD or cause damage to your power tool. Any attempt to repair or replace electrical parts on this power tool may create a hazard unless repair is performed by a qualified technician.
Page 14
CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...