7.2 DISASSEMBLY
Sub Heat Sink
Amp Unit
Panel Unit
Case
Panel Unit
Network Unit
Sub Heat Sink
Heat Sink
GM-X922, GM-X1022
- Removing the Case and the Panel Unit
1. Remove eighteen screws A, seven screws B
and two screws C.
2. Remove Case and Panel Unit.
Fig. 8
- Removing the Network Unit and the
Amp Unit
Some silicone glue has been applied
between the Heat Sink and the Sub Heat
Sink. therefore, to remove the Amp Unit
from the Heat Sink.
1. Remove two screws D.
2. Remove Network Unit.
3. Remove four screws E and nine screws F.
4. Use 2 pcs. of screw E and insert them into the
two holes marked with an arrow.
5. Alternately tighten them little by little until
the Sub Heat Sink separates from the Heat
Sink.
Fig. 9
19