Installation
Chapter 2
After unpacking the unit, immediately inspect it for possible shipping
damage. If damage is discovered, file a claim immediately with the
carrier, then contact ADTRAN Customer and Product Service (CAPS)
Department at the number listed in the back page of the manual.
SETTING THE OPTION SWITCHES
Remove the Circuit Pack from the NT1 Standalone housing by remov-
ing the plastic front panel and sliding the Circuit Pack out of the front
of the unit. Figure 2-1 illustrates switch option locations; Table 2-1 on
page 2-2 lists the function of each switch.
SW1
1
2
3
4
5
6
FRONT
Figure 2-1. NT1 Type 400 Switch Option Locations
61212016L1-20
NT1 T400 User Manual
2-1