Related Manuals for Serene S2026
Summary of Contents for Serene S2026
-
Page 1: Installation Manual
Serene Model 2026/7 Operating & Installation Manual Heating Panel with 24/7 LCD Programming 1 S2026/7... - Page 2 Introduction Serene Heating Panels Serene Convection Heating Panels are available as vertical and horizontal models, providing you with the opportunity to choose a model that will optimise the available wall space. Our new designs have passed rigorous testing and quality assurance controls with both style and safety in mind.
-
Page 3: Safety Information
Regulations require that electrical work be carried out by authorised persons. For your own safety and that of others, ensure this is done. If the supply cord becomes damaged, it must be replaced by a qualified person in order to avoid any hazard. 3 S2026/7... -
Page 4: Safety Cut-Out
Safety Cutout: Serene Convection heating panels are fitted with an auto-reset thermal cutout. This safety device will automatically switch off the elements should the heater reach an abnormal temperature. Should this occur: switch off the heater immediately and allow the heater to cool-down? Overheating is normally caused by blockage of the air vents or by the vents being covered. - Page 5 7: ECO 8: Power indicator 9: Day of the week 10: Heating indicator 11: Low power setting 12: High power setting 14: Manual control 15: Automatic control 16: Timer 17: Hour 18: Minute 19: Real time temperature 20: Temperature S2026/7...
-
Page 6: Program Setup
Press (5 or 6) to set the seconds and press (3) to finish. After setting the seconds the controller will revert back to the day setting as a cycle. Touch button (4) to finish time setting. All time symbols will now stop flashing. 6 S2026/7... - Page 7 The setting program will only save after you have touched the (4) button. The factory pre-setting running time is 07-11；and 13-18hours. When in automatic mode (16) will not display. Your Serene Heating Panel is fitted with a 24 hour clock. 7 S2026/7...
- Page 8 Touch (3) to set the timer and (17) will flash Then touch (5 or 6) to adjust the hour. Touch (3) again to set the minute and touch (4) to confirm. The timer (16) will light up if the setting time is more than the current time 8 S2026/7...
-
Page 9: Overheat Protection
The program memory is retained in the event of any power interruption. Over heat protection: All Serene Heating Panels are equipped with a overheat protection switch that will automatically turn the heater off if for any reason the unit has overheated. -
Page 10: Wall Mounting Instructions
To remove heater from the wall Using a pointed tip screwdriver, push in and lever out the fittings at the top and/or sides of wall mounting bracket. Lift the heater up and away from the wall. 10 S2026/7... -
Page 11: Specifications
Dimensions (mm): W 830 D 75 H 400 Electrical Supply: 230-240 volts A.C. 50 Hz Wattage: 500W-2000W Wiring: Permanent connection or by cord set. Double insulated, no earth required. Ingress Protection Rating: IP24 Serene Industries Limited reserves the right to alter specifications without notice. 11 S2026/7... - Page 12 Contacts: HONG KONG Head Office - Serene Industries Limited t: +852 2325 3209 f: +852 2325 3166 info@serene-ind.com w: www.serene-ind.com Suite 1010, 15F, Block A, Alexander Industrial Building, 62 King Lam Street, Cheung Sha Wan, Kowloon Hong Kong SAR NEW ZEALAND...