Table of Contents
Advertisement
Figure 23. Securing the backplane cable
NOTE:
If your system supports a SAS/PCIe backplane, then you must also secure two additional retention screws that
connect the storage controller cable connector to the system board connector.
3
Install the drive cage.
4
Align the guide on the drive backplane with the guide pin on the drive cage.
5
Lower the drive backplane into place until the guide on the drive backplane engages with the guide pin on the drive cage.
6
Using the Phillips #2 screwdriver, tighten the retention screws to secure the drive backplane to the drive cage.
66
Installing and removing system components
Advertisement
Table of Contents
