Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Configuring In-Band Management
Note If you are executing the setup script after issuing a write erase command, you must explicitly change the default
zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zoneset distribute full vsan 1
Step 22
Enter enhanced (basic is the default) to configure default-zone mode as enhanced.
Configure default zone mode (basic/enhanced) [basic]: enhanced
Overrides the switch-wide default zone mode as enhanced.
Note If you are executing the setup script after issuing a write erase command, you must explicitly change the default
zoning mode to enhanced for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zone mode enhanced vsan 1
Note If you are executing the setup script after issuing a write erase command, you must explicitly change the default
zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zoneset distribute full vsan 1
Step 23 Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip address ip_address subnet_mask
no shutdownip default-gateway default_gateway
no telnet server disable
ssh key rsa 2048 forcessh server enablesystem default switchport shutdown
system default switchport trunk mode
autosystem default switchport mode F
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
system default zone mode enhanced
Would you like to edit the configuration? (yes/no) [n]: n
Step 24 Enter yes (yes is default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]: yes
If you do not save the configuration at this point, none of your changes are updated the next time the switch
Caution
is rebooted. Type yes to save the new configuration. This ensures that the kickstart and system images are
also automatically configured.

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

24
Using the Cisco NX-OS Setup Utility
OL-29291-02