Pontiac G5 Owner's Manual page 107

It may be possible for the PASS-Key
to "learn" the transponder value of a new or
replacement key. Up to 10 keys may be
programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the currently programmed keys are lost or
do not operate, you must see your dealer or
a locksmith who can service PASS-Key
have keys made and programmed to the system.
See your dealer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is cut
exactly as the ignition key that operates the
system.
To program the new key do the following:
1. Verify that the new key has a
2. Insert the already programmed key in the
ignition and start the engine. If the engine
will not start, see your dealer for service.
3. After the engine has started, turn the key to
LOCK, and remove the key.
®
III+ decoder
®
III+ to
If you are ever driving and the security light comes
on and stays on, you may be able to restart
your engine if you turn it off. Your PASS-Key
system, however, is not working properly and
must be serviced by your dealer. Your vehicle is
not protected by the PASS-Key
this time.
1
stamped on it.
If you lose or damage your PASS-Key
see your dealer or a locksmith who can service
PASS-Key
4. Insert the key to be programmed and turn it to
the RUN position within five seconds of the
original key being turned to the LOCK position.
5. The security light will turn off once the key has
been programmed.
6. Repeat Steps 1 through 5 if additional keys
are to be programmed.
®
III+ to have a new key made.
®
III+
®
III+ system at
®
III+ key,
107