Connecting Without A Scart Cable; Connecting Additional Devices - Philips VIDEOPLUS VR630/07 User Manual

Then, read the paragraph 'Preparation for use' in
the chapter 'Installing your video recorder'.
My screen is empty
* Many TV sets are switched to the programme
number for the scart socket by way of a control
signal sent through the scart cable.
* If the TV set does not automatically switch to
the scart socket programme number, manually
change to the corresponding programme num-
ber on your TV set (see your TV's operating
instructions).

Connecting without a scart cable

Have the following cables ready:
an aerial cable.
1.
1.
Switch off your TV set.
2.
2.
Remove the aerial
cable plug from the
aerial input socket of
the TV set. Insert it
into the AERIAL at
the back of the video
recorder.
3.
3. Insert one end of the
supplied aerial cable
into the RF OUT at
the back of the video
recorder and the
other end into the
aerial input socket at the back of the TV set.
4.
4. Insert AC cable into the wall socket.
5.
5.
Switch on your TV set and select the pro-
gramme number used for video playback on
your TV set (see your TV's operating instruc-
tions).
6.
6.
Select this programme number and manually
start the TV's channel search as if you want-
ed to save a new TV channel until the 'test
image' appears.
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P + KEY
OR...
FOR PLAY ONLY - PUSH PLAY
I do not see a TV channel search picture
* Check the cable connections.
* Repeat the channel search on your TV.
7.
7.
You can find more details in chapter 'Preparation
for use'.
Programme number for video recorder oper-
ation
You have now saved a programme number for
use by your video recorder as you would a reg-
ular TV channel. This programme number must
now be used in future for video recorder play-
back ('video recorder' TV channel).
Connecting with an audio cable
[VR730,VR732,VR830,VRQ45]
Have the following cables ready:
an audio cable.
1.
1.
AERIAL
2.
2.
RF OUT
3.
3.
4.
4.

Connecting additional devices

You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
the socket AV2(DECODER).
6
Save this programme number setting on your
TV set for video recorder operation.
Switch off your TV set.
Insert one end of
the auido cable
into the red and
white AUDIO OUT-
PUT L/R socket at
the back of the
video recorder and the other end into the
audio input socket at the back of the TV set.
Insert AC cable into the wall socket.
Switch on your TV set and select the pro-
gramme number used for video playback on
your TV set (see your TV's operating instruc-
tions).
AV2 ( DECODER )
EN