Operation - Fujitsu UTY-LRHYM Operating Manual

OPERATION

To Select Mode Operation
1 Press the "START/STOP" button.
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
The air conditioner will start operating.
2 Press the "MODE" button to select the desired mode.
Each time the button is pressed, the mode will change in the following
order.
s
AUTO
t
HEAT
About 3 seconds later, the entire display will reappear.
To Set the Room temperature
Press the "SET TEMP. (
button: Press to raise the temperature setting.
button: Press to lower the temperature setting.
G Temperature setting range:
AUTO .................................. 18 - 30 °C
Heating ............................... 16 - 30 °C
Cooling/Dry ........................ 18 - 30 °C
The temperature cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the Remote Controller's Display).
About 3 seconds later, the entire display will reappear.
The set temperature should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the "FAN" button.
Each time the button is pressed, the fan speed changes in the following order:
s s
AUTO HIGH
About 3 seconds later, the entire display will reappear.
When set to AUTO:
Heating: Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature
of the air issued from the indoor unit is low.
Cooling: As the room temperature approaches that of the temperature setting,
the fan speed becomes slower.
Fan: The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation and at the start
of the Heating mode.
NOTES
• The QUIET is not available depending on the model. Please refer to the operat-
ing manual for the indoor unit.
QUIET Operation
When set to Quiet:
QUIET operation begins. The indoor unit's airflow will be reduced for quieter operation.
G QUIET operation cannot be used during Dry mode. (The same is true when dry
mode is selected during AUTO mode operation.)
G During Quiet operation, Heating and Cooling performance will be reduced some-
what. If the room does not warm up/cool down when using QUIET Operation,
please adjust the air conditioner's Fan Speed.
NOTES
• The QUIET operation is not available depending on the model. Please refer to
the operating manual for the indoor unit.
En-5
s s
COOL DRY
t
FAN
)" button.
/
s s
MED LOW s QUIET
Example: When set to COOL.
Example: When set to 26 °C.
Example: When set to AUTO.