Operating Accessory Devices With The Tv Remote - Philips 55PP9753 Directions For Use Manual

Operating Accessory Devices with the TV Remote

After having programmed your TV remote,
use the illustrations on pages 25-26 as a refer-
ence to the functions of the remote buttons
with accessory devices.
Before the remote will operate an accessory
device, you must select the correct mode:
CBL (cable box), VCR, DVD, SAT (satellite),
or AMP (amplifier). Here's how:
1
Press the Select button to cycle across
the accessory mode dial. Stop pressing
the button when the mode you desire is
lighted. The light will stay on for two
seconds and then begin blinking. The
blinking means that the remote is in the
accessory mode you have selected.
NOTE: If you do not use the remote
for 60 seconds from the time the acces-
sory mode light begins blinking, the
light will switch off, and the TV will
go back to TV mode. Each time you
press any of the remote buttons when
an accessory mode light is blinking, a
timer is reset to keep the remote in the
accessory mode you have selected.
2
Point the front of the remote toward
the front of the accessory device, then
press the button to perform the desired
function.
H H
ELPFUL
If the remote control is in one of the accesso-
ry modes (mode light flashing)—CBL, VCR,
DVD, SAT, AMP—and you don't press any
of the remote buttons for sixty seconds, a
"time-out" occurs, returning the remote to TV
mode.
c c C
I
HECK
You can change the duration of the time-out
mode by simultaneously pressing the Select
button and a digit button, 1–4. Using digit 1
will set the time-out to 15 seconds; digit 2, 30
seconds; digit 3, 60 seconds; and digit 4, 120
seconds. The default time-out setting after
you replace the batteries in the remote is 60
seconds. All modes will have the same time-
out setting.
INT
O
T UT
GUIDE
POWER SELECT POWER
INFO
HIGH DEFINITION
1
®
® ®
®
24
Point the front of the remote
2
toward the front of the
accessory device, then press
the necessary buttons to per-
form the functions you
desire. Refer to pages 25-26
to see the functions of the
buttons in the respective
accessory modes.
To backlight the
remote control but-
tons, press and hold
the Select button for
two seconds. If you do not press
any remote buttons for five sec-
onds, the backlight switches off.
Each time you press a remote but-
ton while the backlight is on, the
five-second time-out function is
reset. After the backlight switches
off, you must press and hold the
Select button for two seconds to
turn it back on.