Introduction; Installation; Connect The Network And Power Source - Polycom SoundPoint IP 601 User Manual

Introduction

Installation

4
The Polycom SoundPoint IP 601 is a full‐duplex, hands‐free Session
Initiation Protocol (SIP) phone. It provides telephony features such as
Shared Call Appearance, Call Hold, Call Transfer, and Do Not Disturb.
The following instructions provide basic installation instructions.
Contact your system administrator for additional information or
assistance.

Connect the Network and Power Source

Use Power over Ethernet (PoE) for network and power source
connections unless otherwise directed by your system administrator.
NOTE: The AC power adapter is a separate, optional accessory. Your system
administrator will provide one to you if necessary.
AC Power Option
Connect the supplied network
cable between the LAN jack on
the phone and the LAN port on
the wall or hub/switch device
port. Connect the DC plug on the
AC wall adapter to the DC jack
marked on the phone.
In-Line Power Option
Plug the supplied network cable
between the LAN jack on the
phone and an available Power
and Data port on the In‐Line
Power switch if the phone is
connected to a compatible
Ethernet switch.