Enervista 3 Series Setup Software; Hardware And Software Requirements; Installing The Enervista 3 Series Setup Software - GE 350-A9 Quick Start Manual

SOFTWARE SETUP

EnerVista 3 Series Setup Software

Hardware and
software
requirements
Installing the
EnerVista 3 Series
Setup software
72
Although settings can be entered manually using the control panel keys, a PC can be used
to download setpoints through the communications port. The EnerVista 3 Series
Setup software is available from GE Multilin to make this as convenient as possible. With
EnerVista 3 Series Setup running, it is possible to:
• Program and modify settings
• Load and save setting files to and from a disk
• Read actual values
• Monitor status
• Read pre-trip data and event records
• Get help on any topic
• Upgrade the 350 firmware
The EnerVista 3 Series Setup software allows immediate access to all 350 features with
easy to use pull down menus in the familiar Windows environment. This section provides
the necessary information to install EnerVista 3 Series Setup , upgrade the relay firmware,
and write and edit setting files.
The EnerVista 3 Series Setup software can run without a 350 connected to the computer. In
this case, settings may be saved to a file for future use. If a 350 is connected to a PC and
communications are enabled, the 350 can be programmed from the setting screens. In
addition, measured values, status and trip messages can be displayed with the actual
value screens.
The following requirements must be met for the EnerVista 3 Series Setup software.
• Pentium 4 (Core Duo recommended)
• Windows XP with Service Pack 2 (Service Pack 3 recommended) , Windows 7 (32-bit or
64-bit), Windows 8.1 (32-bit or 64-bit), Windows 10 (32-bit or 64-bit)
• 1 GB of RAM (2 GB recommended)
• 500 MB free hard drive space (1 GB recommended)
• 1024 x 768 display (1280 x 800 recommended)
The EnerVista 3 Series Setup software can be installed from either the GE EnerVista CD or
the GE Multilin website at http://www.gegridsolutions.com/multilin
After ensuring the minimum requirements indicated earlier, use the following procedure to
install the EnerVista 3 Series Setup software from the enclosed GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install the no-
charge EnerVista software on the local PC.
3. When installation is complete, start the EnerVista Launchpad application.
4. Click the IED Setup section of the LaunchPad toolbar.
CHAPTER 3: INTERFACES
350 FEEDER PROTECTION SYSTEM – QUICKSTART GUIDE